Storing The Trimmer - GreenWorks 21227 Manual De Utilización

EN
FR DE ES
■ Remove he spool from the cutting head.
NOTE: Remove any old cutting line remaining on the
spool.
■ Cut a piece of cutting line approximately 3m long. Use
only 1.65mm diameter monofilament cutting line.
■ Insert the cutting line into the anchor hole in the upper
part of the spool. Wind the cutting line around the upper
part of the spool clockwise, as shown by the arrows on
he spool. Place cutting line in the slot on upper spool
flange, leaving about 15cm. extended beyond the slot.
Do not overfill. After winding the cutting line, here
should be at least 0.635 cm between the wound
cutting line and the outside edge of the spool.
■ Replace the spool, and the spool cover. Refer to spool
replacement earlier in this manual.

STORING THE TRIMMER

■ Remove the battery pack from the trimmer before
storing.
Problem
String will not advance when using the
auto-feed head.
Grass wraps around shaft housing and
string head.
Motor fails to start when switch trigger is
depressed.
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact he retailer where the product was purchased.
They can take this product for environmental safe recycling.
IT PT NL SV DA NO
Possible cause
String is welded to itself.
Not enough string on spool.
String is worn too short.
String is tangled on spool.
Cutting tall grass at ground level.
Battery is not secure.
Battery is not charged.
Shaft not connected completely.
FI HU CS RU
English
FI HU C
■ Clean all foreign material from the trimmer.
■ Store it in a place that is inaccessible to children.
■ Keep away from corrosive agents such as garden
chemicals and de-icing salts.
■ Store and charge your batteries in a cool area.
Temperatures
temperature will shorten battery pack life.
■ Never store batteries in a discharged condition. Wait
for battery pack to cool and fully charge immediately.
■ Store the battery pack where the temperature is below
27˚C and away from moisture.
■ All batteries gradually lose their charge. The higher the
temperature, the quicker they lose their charge. If you
store your unit for long periods of time without using
it, recharge the batteries every month or two. This
practice will prolong battery pack life.
TROUBLESHOOTING
DISPOSAL
18
RO PL SL HR ET
above or below
Solution
Lubricate with silicone spray.
Install more string.
replacement earlier in this manual.
Pull string while pressing line release button.
Remove string from spool and rewind. Refer
to string replacement earlier in this manual.
Cut tall grass from the top down to prevent
wrapping.
To secure the battery pack, make sure the
latch on bottom of the battery pack snaps
into place.
Charge the battery pack according to the
instructions included with your model.
Make sure lower shaft is fully seated in shaft
coupler on upper shaft and secure shaft
coupler.
LT LV SK BG
normal room
Refer to string