Dimensional Data; Macerating Unit - Liberty Pumps Ascent II-ESW Manual De Instalación

Dimensional Data

ASCENT - ESW
[2cm]
13/16"
[41cm]
16-5/16"
[41cm]
16"
[77cm]
30-1/2"
ASCENT - ESW
ASCENT - RSW
[46cm]
18-3/16"
[9.1cm]
3-5/8"
[24.1cm] [23.6cm]
9-1/2" 9-5/16"
5755000H
ASCENT - RSW
[2cm]
13/16"
[41cm]
16-5/16"
[72cm]
28-1/2"
[51cm]
20"
[18cm]
[51cm] [25cm]
20" 9-3/4"
[24.8cm]
9-13/16"
[51cm]
20"
[3cm] [17.9cm]
1-1/4" 7-1/16"
[27.8cm]
10-15/16"
Copyright © Liberty Pumps, Inc. 2018 All rights reserved.

Macerating Unit

User Interface
The macerator has a user interface
(touchpad with LEDs) located on
the top left side of the unit.
This interface has three LEDs:
ALARM: unit is unable to evacuate
the holding tank or cannot keep
up with the incoming flow.
Audible alarm also activates.
LOW BATTERY: 9V battery needs
to be replaced.
POWER: unit has power.
The interface also has two
pushbuttons:
PUSH to Silence: silences the
[41cm]
16"
audible alarm.
PUSH to Run: overrides the
internal switch to manually run the
macerator and pump.
Alarm
The macerator has an integral alarm that will sound if the unit
cannot remove liquid or keep up with incoming water. If the alarm
sounds, a number of conditions could exist. Refer to the
Troubleshooting section to determine the cause and solution.
A silence button located on the user interface touchpad stops the
audible alarm. The red alarm LED will continue to illuminate.
Discontinue using the product until the problem has been
[41cm]
identified and resolved.
16"
IMPORTANT: In the event of a power outage, a 9V battery will
power the alarm, and if necessary, the macerator will accept two
flushes prior to alarm activation. After that, the unit should not be
used again until the power is restored. The alarm automatically
7"
resets once a normal cycle is performed.
Low Battery
If the yellow LED is illuminated, the 9V battery needs to be
replaced. The expected life of the supplied battery is 5 to 7 years.
Power
The LED will be green when power is applied, but LED must be
steady to operate. Both decorative covers must be properly in
place to engage safety switch.
Decorative Covers
The decorative covers are shipped
from the factory assembled on the
unit. However, during the installation
both covers must be removed from
the macerator.
– 5 –