Receiving The Product; Performance Test; Transporting The Product; Inspecting The Product - Grundfos NBS Serie Instrucciones De Instalación Y Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Receiving the product

3.1 Performance test

The pumps are not tested for performance before leaving the
factory unless it was specifically ordered.

3.2 Transporting the product

WARNING
Overhead load
Death or serious personal injury
Pay attention to the pump weight, and take
precautions to prevent personal injury if the pump
topples or falls by accident.
Always transport the pump in the specified position.
Securely fasten the pump to prevent damage to the shaft and
shaft seal caused by excessive vibrations and knocks.
Do not lift the pump by the shaft.

3.3 Inspecting the product

Confirm that the product received is in accordance with the
order.
Confirm that the voltage, phase and frequency of the product
match the voltage, phase and frequency of the installation site.
See Identification.
Check the product for defects or damages immediately upon
receipt. Any accessory ordered will be packed in a separate
container and shipped with the product.
If any equipment is damaged in transit, report it immediately to
the carrier's agent. Make complete notations on the freight bill.

3.4 Storage after delivery

The contractor must inspect the equipment on delivery and make
sure it is stored so as to avoid corrosion or damage. See Storing
the product.

3.5 Lifting the product

Weight: See the label on the packing.
Motors from 5 hp (4 kW) and up are supplied with lifting
eyes that must not be used for lifting the entire pump unit.
Lift the pump by nylon straps and shackles or a hook as shown
in the figures below.
Correct lifting of pump without base frame
10
Correct lifting of pump with base frame
Correct lifting of pump without motor
Incorrect lifting of pump

Publicidad

Tabla de contenido
loading

Tabla de contenido