Mounting - Tripp-Lite BP Serie El Manual Del Propietario

Mounting (4-Post Rack)
Mount your battery pack in a 4-post or 2-post rack or rack enclosure, or in an upright
tower position. The user must determine the fitness of hardware and procedures before
mounting. If hardware and procedures are not suitable for your application, contact the
manufacturer of your rack or rack enclosure. The procedures described in this manual
are for common rack and rack enclosure types and may not be appropriate for all
applications.
4-Post Mounting
Most external battery packs include the hardware required for 4-post mounting. If this
hardware did not come with your unit, an Adjustable 4-Post Rack-mount Shelf Kit
(models: 4POSTRAILKIT or 4POSTRAILKITHD) may be ordered separately.
1
The included plastic pegs
B while you install the permanent mounting hardware. Insert a peg near the center
of the front and rear bracket of each shelf as shown. (Each front bracket has
six holes and each rear bracket has three holes.) The pegs will snap into place.
After installing the pegs, expand each shelf to match the depth of your rack rails.
The pegs will fit through the square holes in the rack rails to support the shelves.
Refer to the rack unit labels to confirm the shelves are level in all directions.
Note: The support ledge of each shelf must face inward.
A
1
17-05-246-932487.indb 3
A will temporarily support the empty rack-mount shelves
B
A
A
B
3
A
5/31/2017 4:32:24 PM