ATI Radeon Sapphire ML00042-R5 Manual De Instrucciones página 7

6
Screw
Existing
VGA Card
VGA Card
Slot
Screw
VGA Card
Display Cable
To VGA Monitor
(All VGA Cards)
To Flat Panel/LCD Display
(DVI-Ready VGA Cards Only)
Remove any existing VGA Card from your
computer.
Or, if your computer has any on-board
graphics capability, you may need to disable
it on the motherboard. For more information,
see your computer documentation.
(If the old VGA Card sticks, rock it gently
from end to end. Remember to save the
screw.)
Locate the slot. If necessary, remove the
metal cover from this slot; then align your
VGA Card with the PCI/AGP/PCI-E slot, and
press it in firmly until the card is fully seated.
(Grasp the VGA Card by the top edge and
carefully seat it into the slot. Ensure that the
metal contacts are completely pushed into
the slot.)
Replace the screw to fasten the card in
place, and replace the computer cover.
Plug the display cable into VGA Card; then
turn on the computer andmonitor. If your VGA
Card came with a DVI connector, you can
connect a flat panel display to the
appropriate connector, as shown ...
(Make sure all cables are securely
connected.)