Publicidad
Idiomas disponibles
Idiomas disponibles
assembly instructions
Weight Capacity: 300 lbs (136 Kg)
1.
Remove contents from carton.
2.
Place the leg section marked with a "B" into the
groove of the bottom of the seat marked "B". Place
the leg section marked with an "A" on top of the "B"
tube and into the groove of the seat marked "A".
Insert the shorter thumb screw through the middle
hole but do not fully tighten the screw.
3.
Assemble backrest by taking the "L" shaped back-
rest supports and securing them to the back rest
using the shorter thumb screws as shown below.
4.
Attach backrest to the seat by aligning holes on "L"
shaped frame supports with the holes on the leg
section. Secure the legs of the frame marked "B" in
place by using the longer thumbs screws by making
sure to pay attention to the "rear" of the seat
marked on the bottom.
Note: Seat depth can be adjusted by choosing 1 of the 2
holes on the frame supports.
5.
Secure the legs of the frame marked "A" in place
with the remaining 2 longer thumb screws.
6.
Fully tighten the middle shorter middle screw and
2 screws in the B frame and check to make sure all
screws are fully tightened.
7.
Insert legs into leg frame by depressing push pins,
sliding legs over the receptacle and setting to
desired height. Make sure all the legs are set to
the same height.
Publicidad
