Personal Protective Equipment (Ppe); Handling Zbms; Storing Zbms; Transporting Zbms - Redflow ZBM Guia De Inicio Rapido

4.3.

Personal Protective Equipment (PPE)

No particular PPE is required when in the vicinity of a ZBM. However, the following, or equivalent, PPE must be
worn when handling electrolyte or cleaning up an electrolyte leak.
•
Respirator:
• Goggles:
•
Gloves:
Spill kits should be kept on hand at all times. 62L Hazchem spill kits can be sourced from Global Spill Control at:
http://www.globalspill.com.au/.
It should be noted that there is approximately 100L of electrolyte in each ZBM, and while any leak would be
unlikely to result in more than a few millilitres of electrolyte escaping, there is potential for a leak of up to 100L
to occur.
4.4.

Handling ZBMs

ZBMs containing electrolyte weigh 240kg (529lb) and as such, any handling must involve the use of the ZBM's
lifting straps with a forklift or similar lifting mechanism with two personnel on hand.
4.5.

Storing ZBMs

ZBMs can be stored indefinitely, but must always be fully discharged and according to any local or
international codes, regulations or conditions set for goods classified as Dangerous Goods Class 8.
In all cases, ZBMs should be stored on a flat, stable surface in an upright position. The storage area should be
dry and ventilated to the atmosphere, that is, a closed cycle air-conditioned space is not suitable. ZBMs should
also be stored in shaded areas that do not receive direct sunlight, as ultraviolet rays can breakdown the ZBMs
polyethylene components. The electrolyte temperature must remain below 50°C (113°F). It is recommended
that secondary containment is used, such as a catchment tray or bunding (not provided with the ZBM) in the
event of an accidental leak or spill.
4.6.

Transporting ZBMs

Care should be taken to transport ZBMs in an upright position to avoid possible electrolyte leaks. If packaging
is required, suitable materials should be used to manage the Wet ZBM weight of 240kg (529lb).
ZBMs should be transported in accordance with the Redflow Battery Electrolyte Safety Datasheet available in
the ZBM Installation and Operation Manual. However, it is important to note that all transport of wet ZBMs
must also conform to local and/or international regulations. Where possible, transport ZBMs in an area that
has secondary containment, for example, a catchment tray or bunding.
Moldex half-face pre-assembled respirator with multi-gas/vapour cartridges
(available from Protector Alsafe, www.protectoralsafe.com.au: product code 8602A,
part number 0109 0268.
Bollé Blast Duo goggles available from Protector Alsafe,
www.protectoralsafe.com.au: product code 1669211, part number 0708 2904.
Prosafe Premium 806 Blue PVC Gauntlets, available from Protector Alsafe,
www.protectoralsafe.com.au: part number 07841563.
9