Publicidad
die Vorteile: Transienten verursachen weniger wahrscheinlich Clipping und/oder Lautsprecherschäden,
reduzierte Verzerrung und die Beseitigung von Fehlern bei niedrigen Frequenzen bei gleichzeitiger
besserer Abstimmung zwischen dem Leistungsverstärker und Lautsprecher.
Sie haben ebenfalls die Möglichkeit, nur das untere Drahtbrückenelement (mit oberer Drahtbrücke
installiert) zu entfernen, wodurch der untere Tieftöner deaktiviert wird (siehe Abb. 3). Dies ist nützlich bei
kleinen und unregelmäßigen Räumen, wenn zu viel Bass vorhanden ist.
Figure 4a / Figura 4a / Abb. 4a
EN
Out-rigger Spiked Feet & Isolation Pucks
Each Imagine T3 Tower is mounted on a one-piece aluminium plinth and includes out-rigger spiked feet
and a set of four aluminum-rubber isolation pucks. The specially designed spiked feet provide a clean
metal interface with all floor surfaces, while the isolation pucks dampen floor vibrations resonating
from the speaker. Coupled together they anchor the speaker to the floor and prevent dissipation of bass
energy through vibrations.
Out-rigger Spiked Feet
The spiked feet are designed to add stability to the speaker while having minimal floor contact,
which allows for cabinet energy to transmit to the floor and travel away from the speaker to limit any
vibrations.
Isolation Pucks
The carefully-engineered aluminum isolation pucks with rubber dampers isolate the speaker from any
vibrations and decouple the energy of the speaker. They also allow for use of the out-rigger spiked feet
without damaging the hard floor surface.
How to install/remove out-rigger spiked feet (Figure 5)
I.
First lay the speaker down on its side on a soft-padded surface to avoid scratching or damaging
the cabinet.
II. Attach the threaded bolt to the washer and install the bolt through the base of the speaker
stand/plinth.
III. Install each spiked cone onto the threaded bolt and tighten each cone (four total) until the bolt
bottoms out inside the cone.
IV. Slowly lower the speaker towards the receptacle hole on each of the isolation pucks arranged on
Bi-amp / Bi-wire
Figure 4b / Figura 4b / Abb. 4b
Tri-amp / Tri-wire
9
Publicidad
