Inserting/Changing The Batteries - Bosch Quigo Manual Original

Cross line laser
– Cross line laser
– Holder
Dimensions (length × width × height)
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct
sunlight).
B) Only non-conductive deposits occur, whereby occasional temporary conductivity caused
by condensation is expected.
The serial number (9) on the type plate is used to clearly identify your measuring tool.
Assembly

Inserting/changing the batteries

It is recommended that you use alkaline manganese batteries to operate the meas-
uring tool.
Push the locking mechanism (10) in the direction of the arrow to open the battery
compartment cover (7) and remove the battery compartment cover. Insert the bat-
teries supplied.
When inserting the batteries, ensure that the polarity is correct according to the il-
lustration on the inside of the battery compartment.
If the batteries become weak, the laser lines will flash quickly for a few seconds.
Always replace all the batteries at the same time. Only use batteries from the same
manufacturer and which have the same capacity.
Take the batteries out of the measuring tool when you are not using it for a
u
prolonged period of time. The batteries can corrode and self-discharge during
prolonged storage.
Bosch Power Tools
English | 23
Quigo
0.27 kg
0.20 kg
65 × 65 × 65 mm
1 609 92A 4J2 | (10.08.2018)