Scaler; Standard Scaler; Scaler With Led Light (Optional) - Olsen Quality Serie Guía De Operación

To adjust speed: use the adjustment keys (13) to increase or decrease speed. Please see the table below
for speed range for each gear ration value.
To adjust the micromotor water: use the water control
knob (15) on the instruments control panel.
To access setup menu: press and hold the Setting key (12).
Use the Setting key (12) to select the desired option.
To adjust LED options: use the adjustment keys (13) to set
the parameter.
LED Off
To adjust pneumatic activation method: use the adjustment keys (13) to set the parameter.
Micromotor performs speed according to
the pressure on the pedal (14)
To adjust Input pneumatic pressure: use the adjustment keys (13) to set the parameter.
Set minimum activation pressure
from 0.03 to 0.10 MPa
Note: the micromotor system preset by the factory according to the internal equipment pressure. It is not
recommended to change the pressure parameters.

- Scaler

6.4.1 - Standard Scaler

To start the use of scaler it is necessary to first install
the tip that will be used, according to the instructions in
section 6.4.2.
To activate the scaler: it is necessary to remove the
scaler from the support and press the propulsion/activation
pedal (6).
Observe the settings for scaler in section 6.4.3.
The standard scaler is not removable.

6.4.2 - Scaler with LED Light (Optional)

For the use of scaler, it is necessary to connect the
transducer (1) to the coupling (3) and install the tip on the
transducer (1).
To attach the transducer (1) to the coupling: align the
adjustment indicators (2) of the two parts and carefully insert them.
To install the scaler tips: insert the tip into the transducer (1) by threading it carefully,
then insert the Torque wrench (4) into the tip and then rotate it clockwise until it is tight. To
remove the tip, turn it counterclockwise with the Torque wrench (4).
To install a file adapter (not supplied with scaler): attach the adapter to the transducer (1) and screw it
gently. Insert the file into the tip of the adapter, thread the tip and then use the Endo wrench (5) to tighten. To
remove the adapter, use the Endo wrench (5) to loosen it and then carefully unscrew.
The selected program is shown on the display (5).
To select the gear ratio: use Gear Ratio key (10). There are the
following values available: 1:5, 1:1, 4:1, 10:1, 16:1 and 20:1.
The selected gear ratio is shown on the display (4).
To change the rotation direction: use the Direction key (9).
The selected direction is shown on the display (3).
LED On
without delay
with 10s delay
Reverse
LED On
When pedal (14) is pressed micromotor
performs the maximum speed adjusted
Set maximum input pressure
from 0.20 to 0.40 MPa
15
Forward