Parts Identification; Equipment Operating And Description; Before Turning On The Equipment; Turning On The Equipment - Olsen Quality Serie Guía De Operación

- Before Turning On the Equipment

1º - Check if the equipment is properly installed in accordance to the instructions
in the chapter 6 (Installation) of the User Manual Dental Line;
2º - Turn On the air compressor that supplies the equipment;
3º - Open the main water supply valve of the equipment;
4º - Turn On the equipment's power circuit breaker.

- Turning On the Equipment

1º - Turn the On / Off switch (3), its LED indicator will light;
2º - Activate the "Seat Up" command (section 5.3) on the chair base until the
seat reaches its maximum height limit;
3º - Close the pressure valve (2);
4º - Remove the water tank (1) and make sure it filled with water. If necessary, fill it with drinkable water up to
the limit indicated in tank and reattach it again. If you wish to place prophylactic products (low
concentration);
5º - Open the pressure valve (2) and check if the water tank (1) is well attached and free of leaks;
6º - Before starting the use equipment, verify the operation of all instruments and commands available and
perform the cleaning and sterilization of the instruments (chapter 7 of the User Manual Dental Line –
Cleaning and Disinfection).

5.2.1 - Delivery System

1 - Water Tank
2 - Pressure Valve

5.2.2 - Electric Panel

3 - On/Off Switch with LED Indicator
4 - Fuse Holder

4 - Parts Identification

5 - Equipment Operating and Description

7
A - Delivery System
(Item 5.2.1 - pg. 7)
B - Electrical Panel
(Item 5.2.2 - pg. 7)
C - Progressive Pedal
(Item 5.3 - pg. 8)
D - Working Table
(Item 5.4 - pg. 8)
E - Assistant Module
(Item 5.6 - pg. 11)
F - Operating Light
(Item 5.5 - pg. 11)
G - Dental Chair
(Item 5.7 - pg. 12)
H - Water Unit
(Item 5.6 - pg. 11)