Pentair PENTEK DEFENDER CSC-LINK Manual De Instalación Y Operación página 6

INSTALLATION
CONFIGURING MOBILE ACCESS
Configuring your mobile device to interface with the Pentair
Pentek® Well Defender unit requires two steps:
1. Pair your mobile device using the Pentair Home app via a wifi
connection.
The mobile device used to pair the Pentair Pentek Well

Defender must be within range of the router during the
pairing processes.
2. Register the Pentair Pentek Well Defender unit online.
Home App Cloud Connection
Figure 2: Mobile Configuration Overview
Pair the Pentair Pentek Well Defender with Smartphone/Tablet
There are two sub-steps when pairing the Pentair Pentek Well
Defender. Only then can the Pentek Well Defender be fully paired
directly to the App.
First the Pentek Well Defender unit will be paired to your

mobile device.
Then the Pentek Well Defender will be paired to the router via

a web browser on your smartphone/tablet.
1. Disconnect power to the Pentek Well Defender device for 10
seconds, and then return power to the unit to activate local
access or connection mode.
2. Wait until the device's Communication LED is blinking blue.
This step could take up to 5 minutes.
3. Open your mobile device's wifi settings.
To open wifi Settings on smartphones or tablets: Go to

Settings > wifi or Settings > Connections > wifi.
4. Select the network named "PPSxxxxxxx" to connect
your mobile device to Pentek Well Defender.
5. Once connected, the device's Communication LED will
change to a solid blue. The mobile device is now paired to
the Pentek Well Defender device.
6. Open any web browser (i.e. Chrome, Safari, etc.) on your
mobile device to pair the Pentek Well Defender to the
router.
6
Router Connection Communicates with
Well Defender Device
7. Type 192.168.1.1 into the address bar and press enter. This
will take you to the main page for pairing the unit and
mobile device.
8. Click on Settings.
9. Select the router from the drop down SSID list and enter the
router password into the security key field. Passwords
are case sensitive.
10. Click the ADD button to save this wifi network in the device.
11. Scroll down to System Settings area.
A. Verify Upper and Lower Pressure Settings values
are correct. Maximum value for the Upper
Pressure Setting is 100psi.
B. Enter the pump motor's Service Factor Amps (SFA)
value. Maximum value is 12A.
12. Click Apply.
13. To complete the process, youwill now connect the Pentek
Well Defender to the router's wifi directly by disconnecting
your mobile device from the Pentek Well Defender's wifi.
Open your mobile wifi settings.
To open wifi Settings on mobile devices: Go to Settings

> wifi or Settings > Connections > wifi.
14. Disconnect from the Pentek Well Defender's wifi network
or select "Forget This Network" for the PPSxxxxx network.
The Pentek Well Defender's Connection LED will change
to a blinking Green once connected to the homeowner's
wifi network and then turn to solid Green when connected
directly to the internet.
If the Communication LED is Red, verify that the

router's wifi network is working properly.
If the Communication LED stays blinking Green, verify

that the device is setup on the App.
15. Choose how you want to be notified of events by selecting
either Email or Text under the Notification Methods
section of the App.
PN1053 (06-10-20)