Cleaning And Care - Klarstein Partytime 10035294 Manual Del Usuario

EN
22

CLEANING AND CARE

To keep your ice tasting fresh and your ice cube maker looking great, we recommend
cleaning your ice cube maker at least once per week.
1. Stop the ice-making cycle by pressing the Start/Stop button
cube maker from the wall outlet and allow it to warm up to room temperature.
2. If residual water is found in the ice tray, gently push the ice tray back so that all
water drains into the water reservoir.
3. Move the appliance forward to a place 60 mm away from the working table so
that the drain plug becomes accessible. Open the drain plug to drain out excess
water into a bowl, bucket or sink (see figure 1, 2 and 3).
4. Replace the drain plug. Check and make sure that the drain plug is properly fitted
and the water reservoir is closed well. Fill the water reservoir with clean water. Press
the Size selection button
the Start/Stop button
for 6 minutes. It will enter into standby condition after running for 6 minutes. Finally,
open the drain plug and empty the water into a bowl, bucket or sink.
5. Remove the ice basket.
6. Clean the ice cube maker interior with a soft cloth soaked with warm water and
vinegar, then rinse with clean water and then drain all the water.
7. Replace the drain plug well in position. Wash the ice basket and ice scoop in warm
soapy water, rinse with clean water and and dry them.
8. Clean the exterior of the ice cube maker with a soft damp cloth. Use a mild
dishwashing soap, if necessary.
Note: Do not use organic solvent, boiled water, detergent, strong acid and strong
alkali etc. for cleaning.
9. Please empty the water reservoir and dry it for storage if the ice cube maker is not
used for a long time.
until the "Cleaning" indicator
, the pump will start to pump water and will keep running
. Unplug the ice
flashes. Then press