Components; Supplies Required - Bradley S19-304GA Manual Del Instalacion

S19-304GA

Components

Heat Trace Unit
S19-304T (top supply)
S19-304B (bottom supply)

Supplies Required

• (3) 3/8" floor anchors and bolts
• Teflon tape and pipe sealant
• 30 PSI (2.0 bar) min/90 PSI (6.1 bar) max flow pressure
• 125 PSI (8.6 bar) max static pressure
• Piping to 1-1/4" NPT water supply inlet (30-90 PSI/2.0-6.1 bar)
• Piping to 1-1/4" NPT drain outlet on unit (if included with unit)
• Adequate supply pipe supports
• Provisions to dispose of shower and eye or eye/face wash waste water (minimum 30 gallons/115 liters)
should be made (minimum 4"/120mm) drain)
• Optional: sign-mounting hardware
• Optional: for extension cable option, pipe insulation and protective coating are required
NOTICE! Bottom supply units have provisions for supporting the top of the unit. The 1-1/4" NPT solid pipe
protruding from the shell must be used to support the unit.
4
Pull Rod
128-156A
128-157 (316 SS)
Optional Foot Pedal Kit
S45-572 or S45-1314SS16
4/8/2020
Optional Shower
Shroud and
Retaining Nut
Plastic
Stainless Steel
Showerhead
Showerhead
Prepack S45-1535
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817)
http://www.bradleycorp.com
114-052
Safety Sign
(qty. 2)
Emergency Tag
Hex Nut #10-24
(qty. 2)
(qty. 2)
Screw #10-24 x 1/2"
(qty. 2)
Bradley • 215-1856 Rev. D: ECO 19-05-034B
Installation
R
P.O. Box 309, Menomonee Falls, WI 53051
TEST THIS UNIT EACH WEEK
DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAI HEBDOMADAIRE
Test-operate valve(s) each week and sign below.
Report any malfunctions immediately.
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt
durch Unterschrift. Jegliche Störung sofort melden.
Test le fonctionnement des valves chaque semaine et
signe en bas. S'il y à quelque chose qui ne va pas fait
un rapport immédiatement.
Date Signed Date Signed
Datum Unterschrift Date Signed
Date Signe Date Signed
Hook