Connect Water Supply; Assemble Components - Bradley S19-304GA Manual Del Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

S19-304GA
2

Connect Water Supply

NOTICE! Unit requires a minimum 30 GPM to operate and a minimum 30 PSI of flowing water
pressure. Preferred flowing water pressure is 40-60 PSI. Water supply to the unit must be
freeze-protected (by others).
NOTICE! Pipe size should be no smaller than 1-1/4" (supplied by installer).
Connect the water supply piping to the 1-1/4"
A
NPT inlet on the unit, see dimensions (piping
by installer). Use pipe hangers or other means
to provide adequate supports for the supply
pipe (supports by installer).
B
Open water supply lines and test for
leaks and adequate water flow.
NOTICE! In extreme cold weather, run water long
enough to warm non-freeze protected
components of the unit to allow proper
drainage.
3

Assemble Components

Install the showerhead to the unit
A
as shown. The bottom edge of the
showerhead should be 85-7/8"
(2181mm) from the floor.
Mount the safety signs to the wall or to
B
the unit if desired. Use the screws, nuts
and hooks provided to hang the signs
back-to-back on the unit.
C
If optional foot pedal kit is ordered,
attach foot pedal to Halo handle per
foot pedal installation instructions.
6
4/8/2020
Bottom supply units
must use this pipe for
supporting unit.
Use teflon tape
only with plastic
showerheads.
Safety signs
shown mounted
back-to-back.
Bradley • 215-1856 Rev. D: ECO 19-05-034B
Installation
¾" NPT
Junction
Box opening

Publicidad

Tabla de contenido
loading

Tabla de contenido