Usage Of Detergent; Connection Requirements; Instructions For Use - Super Ego 300 Manual Del Usuario

High-Pressure Hose
Use the high-pressure hose (7) to connect the gun (8).
Please use a size 17 spanner to help connect the high
pressure hose to the high pressure connection (2).
Connect the water supply hose (not supplied) to the
water-inlet connector (3).
Jet pipe with nozzle, standpipe, handle gun
The jet pipe with nozzle can only be mounted on
the standpipe and the standpipe only on the manual
spray gun. These components are provided with quick
connectors. Align the pipe coupling with one of the
connections. Press and turn clockwise at the same
time to make the connection. For disconnection, push
the two parts against each other and turn the pipe
counterclockwise.
Use with Detergent
Note: Use a very fluent liquid detergent or else
thoroughly dilute the detergent with water.
Otherwise, the machine will not be able to suck the
soap from the tank and will throw only water.
This pressure washer is provided with a detergent
tank.
The capacity of this tank is about
1.3L.
- For more penetration and to
aid removal of dirt, using the
detergent dispensing function is
recommended.
- Spray the detergent on a dry
surface, do not pre-soak the
area. Wetting the surface
first dilutes the detergent and
reduces its cleaning ability.
- For best results, limit your work area to small
sections of approximately 25 m
- Allow wash to remain on the surface for 1-3
minutes.
- Rinse with pressure water in a long sweeping motion
using a wide spray pattern.
- When moving on to a new section of the cleaning
surface, be sure to overlap the previous section to
remove marks.
Operating instructions
.
2
Very important: Detergent may only be dispensed
when the lance pressure regulation device is set to low
pressure.
⇦
push back
High Pressure
Connections Required
Electrical connection
The machine may only be connected to a properly
installed safety socket. Prior to plugging in, check that
the mains voltage matches that of the machine.
Extension Lead
Only water proof extension leads with high
mechanical resistance and with conductors of at least
3 x 1.5mm cross section may be used.
2
Water Connection
The high-pressure cleaner is suitable for connection to
a standard domestic water supply. Please observe the
regulations of your water supply company.
The supply hose (not supplied) should have the
following dimensions:
Minimum diameter: 1/2".
For the connection values please see table with
technical data.
Operating instructions
A- Use
- The device is intended for private use only.
- The device is used to clean machines, vehicles,
buildings, tools, facades, terraces, garden tools etc.
with the high-pressure water jet.
- It can be used with detergents well diluted in water.
B- Please note
- The cleaning of electric motors or engines and other
surfaces that may be covered with oil is only allowed
in conjunction with an appropriate oil separator.
13
GB
⇨
push forward
Low Pessure
(for detergent)