TOPDON BT100 Manual Del Usario página 5

Battery Test
Healthy: 0 %
Charge: 61%
Internal R=
Rated:
REPLACE
2. Cranking Test
2.1 Before Test
The engine and all other accessory loads must be
have accurate results.
2.2 Steps
1) Connect the RED (+) Positive Battery Clamp to the (+) positive battery terminal,
and connect the BLACK (-) Negative Battery Clamp to the (-) negative battery
terminal. Ensure that the clamps are securely attached to the correct terminals.
2) Press the "M" button to display the Main Menu, and select the
Main Menu
1. Batte ry Test
2. Cranking T est
3. Cha rging Test
4. Review Dat a
5. Language
3) Press "ENTER" to initiate "Cranking Test" interface:
Cranking Test
TIME
CRANKING
10.12V
Reference Table (for 12V battery)
Cranking Voltage Discharge Performance
>10.5V Good
10V~10.5V Not Bad
9.6V~9.9V Bad
<9.5V Very Bad
6
00CCA
12.37V
39.52m Ω
100A
OFF during test in order to
"2. Cranking Test":
1024ms
NORMAL
Actions
No Action Needed
Recharging
Replace
Replace ASAP
3. Charging Test
3.1 Before Test
The engine must be ON during test.
3.2 Steps
1) Connect the RED (+) Positive Battery Clamp to the (+) positive battery terminal,
and connect the BLACK (-) Negative Battery Clamp to the (-) negative battery
terminal. Ensure that the clamps are securely attached to the correct terminals.
2) Press the "M" button to display the Main Menu, and select the
Main Menu
1. Batte ry Test
2. Cranking T est
3. Char ging Test
4. Review Dat a
5. Language
3) Press "ENTER" to conduct a "Ripple Test":
RIPPLE TEST
3) Press "ENTER" again, or wait for a few seconds for "Charging Test" to initiate:
Charging Test
Increase RPM to 2500 r/min and k eep
it 5 seconds.
Press ENTER to continue .
5) The screen will display instructions for the technician to press vehicle
accelerator to increase RPM to 2500r/min and maintain 2500 r/min for 5
seconds. Press "ENTER" to display the test result:
"3. Charging Test":
12.98V
7