To Connect The Piping On Right Side, Right-Back, Or Right-Bottom - Daikin FTXP20L2V1B Manual De Instalación

5 Installation
6 Remove any burrs along the cut section using a half round
needle file.
NOTICE
Do NOT use nippers to remove the pipe port cover, as this
would damage the front grille.
7 Remove the drain plug from the drain port and connect the
drain hose to the port.
NOTICE
Do NOT apply lubricating oil (refrigerant oil) to the drain
plug when inserting it. The drain plug may deteriorate and
cause drain leakage from the plug.
a
a 4 mm hexagonal wrench
8 Shape the refrigerant pipes along the pipe path marking on the
mounting plate.
a
b
c c d
a Drain hose
b Caulk this hole with putty or caulking material.
c Adhesive vinyl tape
d Insulation tape
e Mounting plate (accessory)
9 Pass the drain hose and refrigerant pipes through the wall hole.
10 Set the indoor unit on the mounting plate hooks. Use the " "
marks as a guide.
11 Pull in the interconnection cable.
12 Connect the refrigerant pipes.
13 Wrap refrigerant pipes, interconnection cable and drain hose
together using insulation tape. Overlap at least half the width of
the tape with each turn.
Installation manual
10
14 Take care so the interconnection cable does NOT catch indoor
unit.
15 Press the bottom edge of indoor unit with both hands until it is
firmly caught by the mounting plate hooks.
16 Secure the indoor unit to the mounting plate using 2 indoor unit
fixing screws M4×12L (accessory).
Wall embedded piping
17 Insert the drain hose in the drain pipe as shown in the following
figure, so it will NOT be pulled out of the drain pipe.
To connect the piping on right side, right-back, or
right-bottom
1 Attach the drain hose with adhesive vinyl tape to the bottom of
the refrigerant pipes.
2 Wrap the drain hose and the refrigerant pipes together using
insulation tape.
A
e
a b
3 Pass the drain hose and refrigerant pipes through the wall hole.
4 Set the indoor unit on the mounting plate hooks. Use the " "
marks as a guide.
a b
c
d
2×
f
e
a Drain hose
b Interconnection cable
c Mounting plate (accessory)
d Refrigerant pipes
e Indoor unit fixing screw M4×12L (accessory)
f Bottom frame
mm
INFORMATION
The factory default is right-side piping. For left-side piping,
remove the piping from the right side and install it on the
left side.
C
B
A Right-side piping
B Right-bottom piping
C Right-back piping
a Remove the pipe port cover here for right-side piping.
b Remove the pipe port cover here for right-bottom piping.
(A)(F)TXP20~35L2V1B + FTXF20~71A2V1B
Daikin room air conditioner
3P512025-1 – 2017.11