Permobil ROHO DRY FLOATATION Operación Manual página 8

ROHO DRY FLOATATION Cushion Operation Manual - Dual Compartment, Single Compartment, Sensor Ready
Cushion Adjustment, continued
2. Adjust the cushion:
After overinflating the cushion, adjust to the
Proper Cushion Inflation Setting:
a. The individual should sit in the chair in
their usual position. The cushion should be
centered beneath the individual.
b. Slide your hand between the cushion and the
individual. Lift the leg slightly and feel for the
lowest bony prominence, and then lower the
leg to a sitting position.
c. Open the inflation valve to remove air, keeping
your hand beneath the individual's lowest
bony prominence.
d. Release air until you are barely able to move
your fingertips. Close the valve. Make sure the
inflation valve is closed.
To adjust Dual Compartment Cushions: For individuals with a pelvic obliquity, first adjust the side with
the deepest bony prominence. For front-to-back positioning, adjust the rear section first. Always re-check
adjustment for each section.
The seated figure shows product orientation.
Proper Cushion Inflation Setting
= ½" - 1" (1.5 cm - 2.5 cm)
A) "sink down" into the cushion and
B)"float" above the cushion base.
6
A
B