Playing Arpeggios - Korg RK-100S 2 Manual Del Usuario

RK-100S 2 Owner's Manual
Controlling the filter with your left hand free
1
1. While no sound is being produced, hold down the
SHIFT button and pressthe LONG RIBBON FILTER/
HOLD button.
The FILTER/HOLD button is lit up.
2. Play the keyboard.
Sound continues to be produced.
3. Use the ribbon.
See page 13 "Controlling the filter of the
continuant"
Tip: The direction where the effect is applied when the rib-
bon is used can be changed with the sound editor software
(when the RK-100S 2 is connected to a computer via USB).
4. Press the FILTER/HOLD button again to turn off the
button and stop the continuant.

Playing arpeggios

The arpeggiator is a function that automatically plays a
broken chord (arpeggio) when you hold down a chord
on the keyboard.
1. Select a synthesizer program.
The arpeggiator can also be used with the vocoder
program; however, a better effect can be achieved
with a synthesizer program. In addition, we
recommend a sound with a short sustain.
2. Press the ARP button so that the LED is lit up.
The arpeggiator is turned on.
The ARP button is lit up, and the favorites buttons A
–H are sequentially lit up.
3. Hold down a chord in the keyboard.
An arpeggio will start playing.
The arpeggio pattern that is played can be changed
(see 14 page "Arpeggio pattern settings").
4. Press the TAP button to adjust the tempo.
The TAP button is lit in green, and the tempo
appears in the display.
5. Press the ARP button so that the LED is turned off.
The arpeggio stops playing.
14
1
2
3
4
2,5
1
3
Continuing playing with your hand off
the keyboard (latch)
The operation of the arpeggiator when you take your
hand off the keyboard can be specified.
1. Hold down the ARP button until it is lit up in green.
When the ARP button is lit up in green, the latch is
turned on, and the arpeggiator will continue to play
even after you take your hand off the keyboard.
Note: Regardless of whether the arpeggiator is turned
on or off, holding down the ARP button will turn on the
arpeggiator as well as the latch.
2. Press the ARP button to turn off the arpeggiator.
The latch is turned off at the same time that the
arpeggiator is turned off.
Arpeggio pattern settings
This allows you to select the type of arpeggio produced
when the arpeggiator is on and a keyboard key is pressed.
In addition, notes within the selected arpeggio pattern
can be turned on/off.
1. Hold down the SHIFT button and press the ARP
button.
The arpeggio pattern setting
appears in the display.
With the favorites buttons
A–H used as the arpeggiator
step keys, only the buttons
corresponding to the enabled
steps are lit up (note one).
2. Use the OCTAVE +/- buttons or the SOUND/
FAVORITE BANK lever to specify the arpeggio
pattern.
UP: Notes will be played consecutively from low
pitches to high.
dn (Down): Notes will be played consecutively from
high pitches to low.
AL.1: Up and Down will be alternated. (The highest
and lowest notes will be played once.)
AL.2: Up and Down will be alternated. (The highest
and lowest notes will be played twice, once on the
way up, and once on the way down.)