EUROM VT9 Manual De Instrucciones página 12

ASSEMBLY FAN (T & S)
Only Fan (S) Place foot A (18) on foot B (19) (see diagram).
Now place the lower stand with the stand support (15+17) on the
cross you have created and secure this with the 4 screws supplied.
Undo the clamp coupling (14) and remove. Now slide the stand
cover (16) as far as it will go over the lower stand, until it covers the
stand support (17).
Pull the upper stand approx. 15 cm out from the lower stand and
slide the clamp coupling over the upper stand until it reaches the
lower stand. Then turn it to secure.
Fan (T) & Fan (S): Construct the fan according to the following
diagrams.
Ensure that all screws and bolts are secured firmly.
The front and rear grilles are secured to one another with both
clamps; you then further secure with the nut and bolt at the top of
the grilles (see diagram E).
12
Fan (S)
11. Locking nut
12. Button unit
13. Upper stand
14. Clamp coupling
15. Lower stand
16. Stand cover
17. Stand support
18. Foot A
19. Foot B