Cleaning And Maintenance - EUROM VT9 Manual De Instrucciones

14
The output buttons on the (T) models are located on the base;
they can be found on the button unit on the (S) models.
The fan will now begin to work.
III – If required, you may now depress the oscillation button on top of
the motor: the fan will now begin to oscillate through an angle of 45°.
Depressing and releasing this button will turn the oscillation function
off.
IV – If you would like to angle the fan upwards or downwards, the
motor block can be angled further up or down in relation to the foot.
Before doing so, however, turn off the fan and remove the plug from
the socket!
Press the 0 button to switch the fan off. If you wish to turn the device
off for longer than just a few minutes, you must also remove the plug
from the socket.

CLEANING AND MAINTENANCE

Switch the fan off and remove the plug from the socket if you wish to
clean the device or perform maintenance.
The fan only needs general, exterior maintenance. Dust it regularly
with a soft cloth or duster or use a vacuum cleaner with a soft brush
to clean. If it is very dirty, open the grille and clean grilles and blades
using a soft, damp cloth and a mild household cleaning agent. Dry
everything thoroughly and allow the fan to dry properly before
reassembling and using again. Ensure that water does not come into
contact with anything other than the grille and blades. Never rinse or
spray the fan!
In order to prevent material discolouration or deformities, never use
aggressive or corrosive (cleaning) products.
If the fan is to be stored at the end of the season, repack in its
original packaging: this offers the best protection. Store it in a safe
and dry place that is not subject to extremes of heat or cold.