Human Touch Perfect Chair PC-600 Manual De Uso Y Manitenimiento página 10

11. Plug in the chair, use the recline controller to recline it, then unplug it.
12. Slide the body pad onto the footrest frame, making sure the frame slides into the pockets on the
bottom corners of the pad (Fig.21).
13. Fold the upper part of the pad forward onto the seat (Fig.21).
14. Locate the following cables:
S
• Cable coming through the seat canvas (from the transformer plugged into the power hub) with red wiring.
• Two cables coming from the pad set with black and yellow wiring.
Red cable from seat canvas
S
humantouch.com
Upper part of the pad
Footrest frame installed all
the way into the pocket
S P Black cable from pad set
Fig.21 S
Yellow cable from pad set
16
15. Do one of the following:
Matching the wire colors, connect the three connectors to the corresponding connectors in the connector
S
box attached to the control panel cable. (yellow/yellow, red/red, black/black) (Fig.22).
Connect the black cable coming from the pad set to the control panel cable (Fig.22).
P
16. Install the cable strain reliefs into the connector box slots, push them all the way down,
then snap the connector box cover into place to secure it (Fig.22).
17. Tuck the connector box into the seat canvas.
Red transformer cable
from power hub
S
Black lumbar system
cable from pad set
P
Black lumbar system cable
from pad set
Control panel cable
Yellow jade heat cable
from pad set
Control panel cable
Fig.22
17