Human Touch Perfect Chair PC-600 Manual De Uso Y Manitenimiento página 14

take a seat
Adjust the recline angle
Before adjusting the recline angle, be sure there is nothing located directly behind or beneath the chair.
Gently push the controller backward to recline the backrest, forward to incline the backrest, up to raise
the footrest, and down to lower the footrest. To automatically place the chair in zero-gravity position,
press the controller inward and hold it until the chair stops moving (Fig.35).
NOTE: Lean back against the backrest before reclining the chair. Do not put any extra pressure on
the footrest while reclining, as this may prevent the footrest from properly deploying and locking.
UP to raise footrest
OMNI-CONTROLLER
RECLINE the backrest
DOWN to lower footrest
Fig.35
When adjusting the footrest up and down, you may notice
a slight bumping sensation. This is caused by the footrest
locking mechanism, and is perfectly normal.
humantouch.com
INWARD to move to zero-gravity
INCLINE the backrest
Sensors located underneath each
armrest stop the chair from reclining
should anything become wedged
between the pad set and the armrest;
this is a safety feature.
24
Using your Human Touch Perfect Chair
adjust the chair to the desired position. The Perfect Chair cradles you
in zero-gravity comfort, with your feet above your heart—the ultimate
neutral-posture position for stress relief.
Adjust the headrest
While seated, reach up with both hands and grasp
both sides of the headrest. You will feel the rigid
frame beneath the soft head pad. Grasping the
rigid frame, tilt the headrest forward or backward
for maximum comfort. The headrest remains in this
position until you adjust it again (Fig.36).
C
Adjusting lumbar support
1. To decrease lumbar support, sit in the chair, lean against the
backrest, then push the ball valve on the back of the body pad.
When the lumbar support reaches the desired thickness, release
the valve.
2. To increase lumbar support, lean forward to remove pressure
from the pad, then push the ball valve inward. When the lumbar
support reaches the desired thickness, release the valve. It takes
approximately ten seconds for the lumbar support to fully inflate.
Lumbar support performance notes
• You must remove all body weight from the pad when increasing lumbar support.
• If the lumbar support has been compressed for a long period of time, it may take up to one minute to restore it
to its full thickness.
• The colder the pad is, the longer it takes to react to lumbar support changes.
• Should the ball valve leak during use, push the black ball in and, with a cotton swab, apply a small amount of
Vaseline inside the valve. NOTE: It is normal for the lumbar support to return to a fully expanded state over time.
• Keep sharp objects away from the pad. The pad contains a precision air-tight bladder which that will not
function properly if punctured.
is easy. Just take a seat and
Fig.36
Body pad
25