Amplicomms AW 500 Manual De Instrucciones página 12

Analogue dial time setting
1 Pull out dial (4) to adjust analogue time.
2 Push dial (4) back in when done.
Digital time setting
(The same setting procedures applies to both 24-hr and
12-hr mode, with the additional steps to change the AM/PM
letters in the 12-hr mode.)
1 Press and hold down button 1 for approx. 1.5 seconds
until the hour digits will flash.
2 Press button 3 to set the hours. Keep the button pres-
sed to cause a faster change.
3 Press button 5 to confirm the setting; the minute
digits will flash.
4 Press button 3 to set the minutes. Keep the button
pressed to cause a faster change.
5 Press button 5 to confirm the setting.
• If the clock is set to 24h-mode, proceed with step 8.
• If the clock is set to 12h-mode, either the character "A"
(for AM) or "P" (for PM) will flash.
Helpline UK 0844 800 6503
(See on page 15 for costs and hours of operation)
S
ETTINGS
9