Kohler K-1397-H2 Manual De Instrucciones página 2

19-5/8"
15-5/8"
(49.8 cm)
(39.7 cm)
17-1/2"
(44.5 cm)
4-1/8"
(10.5 cm)
3" (7.6 cm)
3-1/2" (8.9 cm)
3" (7.6 cm)
Product Information
Applicable product:
Whirlpool with chromatherapy lights
Whirlpool without chromatherapy lights
Fixture*:
Bathing well:
Basin area, bottom 61" (154.9 cm) x 46" (116.8 cm)
Basin area, top 68" (172.7 cm) x 58" (147.3 cm)
Weight 290 lbs (131.5 kg)
To overflow:
Water depth 20" (50.8 cm)
Capacity 215 gal (814 L)
* Approximate measurements for comparison only.
Pump: (Qty. 2)
Variable speed
Included components:
Cut-out template, top (drop-in)
Cut-out template, bottom (drop-in)
Cut-out template, top (flush-mount)
Cut-out template, bottom (flush-mount)
Required accessories:
Flexjet trim kit
Transfer valve trim, lever handle OR
1022205-1-E
29-1/16" (73.8 cm)
23-5/16" (59.2 cm)
27-1/2"
30-1/4"
(69.9 cm)
(76.8 cm)
75" (190.5 cm) D.
9/16" (1.4 cm)
2" OD
K-1397-H2
K-1397-H3
V Hz A
240 50/60 18
1000554-7
1000555-7
1000556-7
1000557-7
K-9398
K-T9540-4
No change in measurements with drain
shown. (K-7167 or K-7167M)
Hot/Valve (Supplied)
Cold/Valve (Supplied)
3/4" (1.9 cm) D.
Supply to
Valves
Pump/Control Access
48" (121.9 cm) W x
18" (45.7 cm) H Min
2-1/2"
(6.4 cm)
25" 23-1/2"
(63.5 cm) (59.7 cm)
Required accessories:
Transfer valve trim, round handle
Handshower
Faucet handles
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with a Class A
Ground-Fault Circuit-Interrupter (GFCI) or Residual Current
Device (RCD):
Pump/control/heater
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of 54
lbs/square foot (265 kg/square meter) loading.
Two separate 240 V electrical services required; one for the
pump/control, and another for the heater.
Consult local and national codes for minimum air gap
requirements when installing a spout on the faucet deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
Fixture conforms to ANSI Standard Z124.1.2. All dimensions are
nominal.
2
Handshower [1-1/4" (3.2 cm)
D. Hole] (Not Supplied)
Transfer Valve (Supplied)
Valve Detail
K-T9540-7
Varies
Varies
208-240 V, 20 A, 50/60 Hz
Kohler Co.