Scott Living 2026VA-30-200 Instrucciones De Montaje, Cuidado Y Uso página 4

INSTALLATION INSTRUCTIONS
Note: Clean area where the vanity (A) will be
permanently located prior to beginning
installation, ensuring the vanity (A) will not
interfere with any water supply and drain
lines once mounted.
2. With two people, carefully place vanity (A) with
top (B) against the wall in its final location.
Find and mark locations of wall studs behind
the permanent location of vanity (A).
From inside vanity (A), drill hole through
vanity mounting area into wall studs.
Using mounting hardware (not included)
appropriate for your installation site, secure
vanity (A) to wall stud. If possible, secure
vanity (A) to two wall studs for increased
stability.
Note: Use preassembled levelers on legs of
vanity (A) to level the item. Twisting the
levelers counterclockwise will increase the
height of vanity (A), twisting them clockwise
will decrease it.
WARNING
Vanity (A) MUST be secured to wall.
3.To reinstall drawers into vanity (A), fully extend
metal glide tracks. Gently lower and slide
drawer box into rear glide catch. Next lower
drawer box down to completely rest on
extended glides. Then, push plastic levers to
lock the drawer box in place.
Repeat for remaining drawer.
Note: To Adjust the drawer box height, Spin
the adjustment wheel to the left to raise the
drawer box or spin the adjustment wheel to
the right to lower the drawer box. You can
adjust the left and right side glide heights
independently in order to find the drawers best
alignment position.
CAUTION
DO NOT force drawer or damage to glide may
occur. If drawer does not slide in with ease,
remove and try again from the start.
2
A
3
B
A
1
4
B
3
2