Kohler K-704410 Guia De Instalacion página 10

Hanging Bracket
Blind Nut
Rollers on same side
as bottom frame hole
7. Install the Hanging Brackets — Inside Panel
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set unframed tempered glass directly on the floor.
Insert a bushing into one of the holes at the top of the inside glass panel.
Install a hanging bracket over the glass panel, aligning the hole in the bracket with the bushing.
Insert a blind nut into the hanging bracket hole and bushing. Secure with a #8-32 x 3/8" machine
screw.
Repeat the steps to install the other bracket on the inside panel.
IMPORTANT! The steel side of the roller must be installed against the hanging brackets.
The inside panel is installed on the showerhead side of the bath or shower.
Install the rollers on the same side as the bottom frame holes.
Assemble the rollers and #8-32 x 3/8" machine screws to the hanging brackets through the center
hole of the bracket.
Secure the rollers.
1015439-2-C
Roller
Bushing
8-32 x 3/8" Machine Screw
Bolt
Install inside panel roller.
10 Kohler Co.