Cleaning the shaver
2
1
1
1
Insert the appliance
plug into
self-cleaning
recharger.
2
2
Plug in the adaptor.
•
Remove any soap or water on
the shaver if it has been
washed with hand soap or
any other detergent.
Course selection indications
On recharger
Course
CLEAN
DRY
1Charge
2 Clean/Dry/
Charge
3Clean/Dry
4Dry/Charge
5Dry
*The lamp goes out in 6 seconds.
8
5
4
3
3
3
Pull up the arm.
4
4
Remove the protective
cap and then attach the
shaver.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not
deformed or damaged when you are
attaching the shaver.
5
5
Push down the arm.
Changeable course
halfway through
CHARGE
*
2345
3
2
235
234
6
6
Press [SELECT] to select the course.
•
Each time you press [SELECT], the course changes from
"Clean/Dry/Charge"
"Charge".
•
The courses start approximately 6 seconds after they are
selected.
•
The course will be aborted if the power is cut off. In this
case, perform the course again from the beginning.
•
Do not detach the detergent cartridge or the water tank as
the cleaning liquid may spill causing a malfunction.
Course completion summary
On shaver
On recharger
CLEAN
DRY
Glows
Glows while
charging
–
Glows while
charging
–
"Clean/Dry"
"Dry/Charge"
On shaver
Time required
(guide)
CHARGE
Blinks
1 hour
Blinks
4 h 0 min
–
hours
Blinks
4 h 0 min
–
h 50 min
"Dry"