Connect The Water Supply To The Machine - GreenWorks Pro PW18HYB Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
Use priming valve when using siphon tube.
1. Before installing the included high pressure hose, place
the priming valve (31) onto the pressure washer outlet (9)
and rotate clockwise until tightened.
2. Or directly connect the high pressure hose (20) to the water
outlet (9), when not using the siphon hose.
Water exiting the priming valve is normal. This valve
bleeds air from the pump and will enable the siphon
function.
4.12
INSTALL THE BATTERY PACKS
This machine only works if two charged battery packs are
properly installed into the unit.
If the battery pack or charger is damaged, replace the
battery pack or the charger.
Stop the machine and wait until the engine stops before
you install or remove the battery pack.
Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery door.
2. Align the ribs on the battery pack (24) with the grooves in
the battery compartment (5).
3. Push the battery pack (24) into the battery compartment
until the battery pack (24) locks into place.
4. When you hear a click, the battery pack (24) is installed.
WARNING
WARNING
WARNING
WARNING
English
5. Close the battery door.
5
OPERATION
Make sure that all the connections are tight and have no
leakage before operation.
5.1
CONNECT THE WATER SUPPLY
TO THE MACHINE
For easy operation, please use a self-coiling garden hose (not
provided).
When you operate the self-coiling hose, make sure that the
hose has no blockage.
The water supply must come from the water main
Do not use hot water
Do not use water from ponds or lakes
Always observe all the local regulations when you connect
the garden hose to the water supply. Direct connection
through a receiver tank or backflow preventer is usually
permitted.
Inspect the filter in the water inlet connector before you
connect the garden hose
If the filter is damaged, do not use the machine until the
filter is replaced.
If the filter is dirty, clean the filter.
1. Uncoil the garden hose (21).
2. Let the water flow through the garden hose (21) for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose (21) to the
water inlet (6) connector.
12
WARNING
WARNING
WARNING
WARNING
CAUTION

Publicidad

Tabla de contenido
loading

Tabla de contenido