Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning function ("Clean" function)
The appliance has an internal cleaning function. Proceed as follows to use the
cleaning function:
1.
The appliance should be in standby mode (power LED flashes). If this is not
the case, press the "POWER" button once.
2.
Fill the water tank with water if necessary.
3.
Press the "Select" button until the "CLEAN" LED lights up.
4.
Then press the "POWER" button to start the cleaning process.
5.
The appliance automatically runs a cleaning program, which consists of 6
individual cycles with a total time of about 8 minutes.
6.
Run the cleaning program again if the taste is not as fresh as expected.
Note: We recommend that you carry out the cleaning process first using a gentle
cleaning agent and then another cleaning cycle with fresh water to remove all
cleaning residues.
8. Troubleshooting
Error
"ADD WATER" LED
lights up
"ICE FULL" LED
lights up
Ice cubes are
sticking to each
other
34
Cause
• Low water level
• Sensor is blocked
• Pump is faulty
• Ice collector is full
and the light barrier is
blocked
• Light barrier is faulty
• Water temperature is
too low
Troubleshooting
• Fill the water tank
• Clean the sensor
• Please contact our customer
service department
• Empty the collector
• Check the light barrier
• Fill the water tank with water
at a temperature of between
8°C and 25°C
English
Publicidad
