Testing Your Fan - Craftmade Wyman WC42-1 light Guia De Instalacion

9. Light Kit Assembly (Optional). (cont).
Locate cap in one of the hardware
packs and place cap firmly into hole in
middle of switch housing cap.
Align holes in switch housing cap with
holes in switch housing. Secure switch
housing cap with 3 screws (and star
washers) that were removed at the
beginning of Section 9 (page 7), "Light
Kit Assembly (Optional)." Tighten all
3 screws securely.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable).
Test fan speeds with the pull chain on switch
housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will
again set the fan to OFF setting. If applicable,
test light with pull chain in the middle.
(diagram 1) If fan and/or light do/does not
function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to
recirculate air depending on the season:
- DOWN position in summer
(diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling
a difference in your comfort.
IMPORTANT: Reverse switch must be set
either completely UP or completely DOWN for
fan to function. If the reverse switch is set in
the middle position (diagram 4), fan will not
operate.
Attach pull chain extension(s) supplied or
custom pull chain extension(s) (sold
separately) to end(s) of the pull chain(s).
motor housing
switch
housing
cap
motor housing
fan pull
chain extension
diagram 1
diagram 2
page 9
cap
reverse
switch
light pull chain
extension
diagram 3
diagram 4
switch
housing