Operating Instructions; Care And Maintenance - HAMPTON BAY WDF9-2 Guía De Uso Y Cuidado

Operating Instructions

1. Make sure rotary switches are in the OFF position.
2. Plug into 120V AC electric outlet.
3. Set the individual fan motors on either In ( intake ), Out ( exhaust ) or Exch
(exchange) using the control lever.
4. Turn the Thermostat Control to its highest setting (full clockwise).
5. To start the unit turn the rotary switches to desired speed: 0=Off, 3=High,
2=Medium, 1=Low.
6. While the window fan is on, turn the Thermostat Control counter-clockwise towards
the smaller dots until the fan stops (Away from Cooler). This is the selected comfort
level.
7. If the fan is stopped and you want to turn it back on, turn the Thermostat Control
clockwise until the fan starts, towards the larger dots (Towards Cooler).

Care And Maintenance

TO CLEAN: Always disconnect the power cord from the electrical outlet when
cleaning your fan. Light accumulated dust can be removed by using a soft cloth to wipe
away the dust at the back grille of the fan. Wipe the exterior surfaces of the fan
occasionally with a damp cloth (not dripping wet) and dry thoroughly with a soft dry cloth
before operating the fan. Do not use harsh cleaners or materials to clean this unit, doing
so will cause damages to it
CAUTION: DO NOT ALLOW WATER TO RUN INTO THE INTERIOR OF THE FAN AS THIS
COULD CREATE A FIRE OR ELECTRIC SHOCK HAZARD. THE FAN MOTOR IS FACTORY
LUBRICATED FOR LIFE AND WILL REQUIRE NO FURTHER LUBRICATION NO OTHER USER
MAINTENANCE IS REQUIRED OR RECOMMENDED. IF SERVICE IS REQUIRED, SEND YOUR
FAN TO THE AUTHORIZED SERVICE FACILITY.
TO STORE: Make sure to disassemble and clean the fan before storing. Retain the
original packaging for the purpose of storing your fan. Always store fan in a dry place.
Never store it while it is still plugged in. Never wrap the cord tightly around the fan, and
do not put any stress on the cord where it enters the fan, as it could cause the cord to fray
and break.
8