Maintenance And Cleaning - Rowenta DW9220 Manual Del Usuario

Ocultar thumbs Ver también para DW9220:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 33
7 • Spray
Press the spray button to moisten difficult creases fig.10 . You can use the spray function
at any temperature.
8 • Anti-Drip system *
It prevents water dripping out of the soleplate when the temperature is too low.
9 • Auto Off function*
• For your safety, the electronic system cuts off the power and the auto off indicator
light flashes
fig.11
- The iron remains motionless for more than 8 minutes on its heel
- The iron remains flat or on its side for more than 30 seconds
To restart the iron, just move it gently until the warning light stops flashing.
AFTER USE
10 • Emptying
fig.2
Unplug the iron
. Pour away remaining water
Set the temperature control dial
11 • Storing
Allow the appliance to cool down before winding the cord around the heel. Store the iron
on its heel in a dry and safe place fig.14 .
IMPORTANT Do not wind the cord around the hot soleplate. Never store your iron
placed down on the soleplate.

MAINTENANCE AND CLEANING

Remove the plug from the wall socket and let the iron cool down before
maintenance and cleaning.
12 • Anti-scale system
Your iron contains an anti-scale cartridge to reduce scale deposits.
This considerably prolongs the operational life of your iron.
The anti-scale cartridge is an integral part of the water tank and does not need to be
replaced.
13 • Cleaning the iron
When the appliance has cooled down, wipe the iron down with a damp cloth or sponge. A non
abrasive cleaning agent can be used.
Alternatively the ROWENTA cleaning kit ZD100 D1 can be used. After cleaning the soleplate,
use the Self Clean function to remove residues of the cleaner from the steam holes.
IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean the
soleplate and other parts of the iron.
14 • Self Clean
WARNING : Do not use descaling agents even if advertised for steam irons. They will
permanently damage your iron.
The Self Clean function flushes dirt and scale particles out of the steam chamber.
1. Fill the water tank with untreated tap water up to the max mark and heat the iron to the
••• temperature. Switch off the steam.
2. Unplug the iron and hold it over a sink horizontally.
3. Push the self clean button for 1 minute fig.13a-13b and shake the iron gently: steam
will now begin to build up. After a few seconds water will emerge from the soleplate,
rinsing dirt and scale particles out of the steam chamber.
4. Plug in the iron and allow the iron to heat up again. Wait until the remaining water
has evaporated.
5. Unplug from the mains and allow the iron to fully cool down. When cool, the soleplate
can be wiped with a damp cloth.
TIP Use the Self Clean function approx. every 2 weeks. If the water is very hard,
clean the iron weekly.
(*) Depending on model
when:
fig.3
on position Min. Set the iron on dry position
(prolongs the life of the iron)
fig.12
.
5
EN
.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dw9226

Tabla de contenido