Work Procedure For Wall Sawing; Start Blade Rotation; After Work Is Completed; Water Valve - Dimas PP 455E El Manual Del Propietario

Operator's Manual PP 455E
Work procedure for wall
sawing

Start blade rotation

1. Turn the controls for blade rotation and water coolant
to their maximum positions to start blade rotation and
the water coolant.
The amount of water can be adjusted manually with
the knob on the top of the unit.
2. Start the blade motion by turning the blade motion
knob on the remote control in the desired direction.
3. Start the horizontal motion by turning the horizontal
motion knob in the desired direction.

Work procedure for wall sawing

After work is completed

1. After the work is completed, turn off the blade rotation
and water flow by turning the blade rotation and water
coolant start knobs on the remote control back to "0"
2. Turn off the electric motor by pressing the remote
control's green button.

Water valve

When the power to the hydraulic unit is disconnected, the
water valve opens so that the cooling system can be
drained prior to transport and to avoid the risk of the
cooler and motor freezing in sub-zero temperatures. The
unit can be transported vertically or horizontally. If the
power is cut during sawing, the water can be turned off by
turning the water flow valve on top of the power unit
clockwise to the stop position. The water flow connected
to the hydraulic tool can also be reduced by turning the
water flow valve.
English - 17