Charge The Battery - Dimas PP 455E El Manual Del Propietario

Operator's Manual PP 455E
7. Battery status (only machines equipped with a radio)
This function checks the remote control's battery.
Different messages are shown on the display,
depending what is currently happening with the
battery:
• 0% BATTERY 100%
When the remote control is connected and the battery
is being charged a horizontal column is shown below
the 0 % - 100 % scale. The column length against the
scale shows how much of the charge remains in the
battery.
• CHARGING THE BATTERY
Shown when the remote control is connected and the
battery is charging. The charging time from 0 % to
100 % is approximately 9 hours.
• BATTERY FULLY CHARGED
Shown when the battery is charged to 100 %.
• BATTERY DISENGAGED
shown when the battery is disengaged from the remote
control. The message is also shown when the charging
unit in the remote control has been damaged.
Work procedure for wall sawing

Charge the battery

NOTE!
This chapter only concerns machines
equipped with a radio.
The remote control is equipped with a 7.2 volts battery.
The emergency stop on the remote control should always
be in the extended position when charging.
The battery can be charged as follows:
With the Canbus cable (Part No. 531 11 50-12)
With the charging cable to the 12 volts outlet in the car
(Part No. 531 14 20-92)
With the charging cable to the battery charger (Part No.
531 11 72-54)
With the Canbus cable
Connect the Canbus cable between the remote control
and the unit. Make sure that none of the emergency stops
are pushed in and that the power unit is voltage fed.
Display "CHARGING THE BATTERY".
The power unit can be used during charging.
Charging takes approximately 10 hours.
With the charging cable
Connect the charging cable between the remote control
and the 12 volt outlet in the car. Check that the emergency
stop on the remote control is not pushed in. The display
shows CHARGING THE BATTERY when charging is in
progress.
The charging time is approximately 6 hours.
NOTE! ONLY 12 V
To charge with the battery charger
Connect the charging cable between the remote control
and the battery charger. Now connect the battery charger
to a 230 volts mains socket. Check that the emergency
stop on the remote control is not pushed in. The display
shows CHARGING THE BATTERY when charging is in
progress.
The charging time is approximately 6 hours.
NOTE
ONLY 230 V
English - 21