Settings - Dimas PP 455E El Manual Del Propietario

Work procedure for wall sawing
8. Radio channel
When the remote control is only used in battery mode,
a radio antenna must first be connected to the unit:
Remove any cable connection.
Push in the antenna's connector in the socket on the
hydraulic unit. Make sure that the slot in the antenna
connector aligns in the socket.
Screw on the connector's ring on the socket.
A radio channel must be selected when the antenna is
connected. Select:
0, 1 or 2
Confirm the selection by pressing OK and then arrow
down. The main information "Status" is then shown on
the display. Press arrow down again to continue in the
operations menu.
22 - English

Settings

All Setting options for the hydraulic unit and the remote
control are accessed via this sub-menu.
A four digit code must be entered to access the settings
sub-menu. This code is 0012.
The code is stated one digit at a time, from left to the right.
The arrow keys scroll from 0-9 and the OK button confirms.
The "SETTINGS" menu consists of seven sub-menus,
which in turn consist of a number of part menus:
1. Select language
2. Adjust the hydraulic valve for the blade
3. Adjust the hydraulic valve for the feed
4. Sensor on/off calibrate
5. Hydraulic unit settings
6. Basic setting
7. Out settings
The numbers refer to the following headings.
1. Select language
Using this sub-menu you can set the language you
wish to use on the display.
The sub-menu always has the heading in English. The
selected language is stated under heading.
To select the language:
• Scroll using the arrow keys until the required language
is shown.
• Press OK.
• Press the down arrow to continue to the next sub-
menu.
2. Adjust the hydraulic valve for the blade
This sub-menu contains setting options for the rotation
of the blade and consists of three part menus:
2.1 Change the start point for the blade
2.2 Change the end point for the blade
2.3 Change the ramp time for the blade
2.1. Change the start point for the blade
The start point value should be adjusted so that the
blade rotation is as low as possible when the blade rota-
tion knob (pos. 2) is turned from its left-hand position.
A too low value results in the need to turn the knob
before the blade starts to rotate.
A too high value results in the blade rotating too quickly
when the knob is turned.
Operator's Manual PP 455E