Dismantling The Equipment; Work Procedure For Wire Cutting - Dimas PP 455E El Manual Del Propietario

Work procedure for wall sawing

Dismantling the equipment

1. Allow the motor to stop completely.
2. Disconnect the power supply cable before
disconnecting the water hoses.
3. Disconnect the hydraulic hoses.
4. If there is a risk of freezing, drain the water from the oil
cooler by disconnecting both hoses, opening the water
flow valve, and tilting the unit forwards.
CAUTION
Always clean all the equipment at the end of
the working day. Do not use a high pressure
washer to clean the machine.

Work procedure for wire cutting

When all the equipment has been assembled cutting can
start. In order for the saw to cut as efficiently as possible it
should be started as follows:
1. Assemble the pressure reduction block supplied with
the wire saw on the hydraulic unit according to the
instructions on the block.
2. Connect the two smaller hydraulic hoses to the
pressure reduction block. The hoses in the hose
assembly marked with a red disc by the coupling shall
be connected to the hose on the pressure reduction
block that is also fitted with a disc.
3. Close the valve on the pressure reduction block by
turning the knob anti-clockwise until it stops and then
two turns back.
4. Start the electric motor by pressing the remote
control's green button once.
18 - English
Press the green button on the remote control once
more to stop the motor.
5. Set the feeding flow on the unit to max by turning the
control on the remote control clockwise.
6. Tension the wire by carefully turning the knob on the
pressure reduction block clockwise until the wire is
tensioned sufficiently. Make sure to always check that
the wire is seated correctly in all the wheels on the
saw.
7. Start the wire drive by turning the control for motor
rotation on the remote control clockwise.
Operator's Manual PP 455E