NAMCO VAMPIRE NIGHT DX Manual Del Operador página 37

5-1 Removing the Header Assy
The Header assy has a forward centre of gravity, so it is important that at least
two (2) people are used to fit or remove the Header assy.
The fitting position of the Header assy is high, and it is important that a means of
reaching the height safely, without stretching, is available, (e.g. steps, step stool, etc.).
1. Place the Header Assy on to the top of the Monitor Cabinet, and connect the
connector.
2. Slide the Header Assy back, taking care not to trap any wires, so that it engages
under the retaining bracket.
3. Fit 3off hex head screws (M6x30) to retain the Header Assy in position.
Hex head screw (M6x30)
Header Assy
Page 37
Retaining bracket