Operation - Glacier bay HD67540-1008D2 Guía De Instalación Y Cuidado

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the hot and cold water supplies. Check for leaks.
1a
Unfiltered water model
□
Pull the hose assembly out of the spout and
remove the spray head by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn the faucet to the warm position
where it mixes hot and cold water.
□
Pulling the handle towards yourself will turn
the water to cold. Pushing the handle away
from yourself will turn the water to hot.
□
Flush the water lines for one minute. This
flushes away any debris that could cause
damage to internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but
do not overtighten. Reinstall the spray head
by hand tightening it back onto the spray
hose in a clockwise direction.
Hot
Cold
Open
1b
Filtered cold water model
□
Make sure the the faucet is closed and do not
open the handle outward, as shown in the Fig 1.
□
Maintain the state of the Fig 1, pulling the handle
towards yourself will activate the filtered water,
as shown in the Fig 2.
□
Flush the water lines for one minute. This
flushes away any debris that could cause
damage to internal parts. Check for leaks.
□
Maintain the state of the Fig 1, pushing the
handle away from yourself will turn off the
filtered water, as shown in the Fig 2.
Fig 1
Fig 2
15
Please contact 1-855-HD-GLACIER for further assistance.
Keep inward
OFF
ON
HOMEDEPOT.COM/GLACIERBAY