9. DIAGNOSTICS LED
DL1V (green) + DL1R
(red)
DL2 -
red
DL3 -
red
DL4 -
red
DL5 -
green
DL6 -
green
DL7 -
green
DL8 -
green
DL9 -
green
LED: DL1V
(green) + DL1R
Leds DL1R and DL1V displays any mistakes with a series of pre-set flashes:
Key:
led always on;
/
Alternate flashing (Red/Green):
/
Fast flashing of both
(Red/Green):
/
1 flash every 4 seconds
/
No. 8 flashes interspersed with
a pause of 1 sec. (Red/Green):
LED: DL1V
(green) + DL1R
1 flash every 4 seconds (green):
1 flash every 1 seconds (continuous
flashing)
Always on (green):
Fast flashing (green):
Flashing (green):
Led off:
LED: DL1V
(green led always off) + DL1R
Led off:
1 flash every 1 seconds (red):
No. 2 flashes interspersed with
a pause of 1
sec.(red):
No. 3 flashes interspersed with
a pause of 1
sec.(red):
No.
6
flashes
interspersed with
a pause of 1 sec. (red)
Led indicating the programming of REMOTE CONTROLS, ERRORS and the
status of the control unit
OPEN button LED signal
OPEN/CLOSE button LED signal
PEDESTRIAN button LED signal
STOP button LED signal
SENSITIVE EDGE LED signal
PHOTOCELL LED signal
OPEN LIMIT SWITCH LED signal (FCA)
CLOSE LIMIT SWITCH LED signal (FCC)
(red)
led flashing;
Saving to be performed;
Saving in progress;
Status of the unknown position - Next maneuver
REALIGNMENT
Eeprom data error;
Perform procedure RADIO MEMORY RESET;
(red led always off)
Normal operation;
Radio memory of the card is read by TAUSOFT
Channel CH1 waiting to be saved;
CH1 channel memory full;
CH1 channel waiting to be cancelled;
Cancelling of channel CH1 in progress;
Normal operation;
Phototest error
Disable phototest (dip-switch 6 OFF), check the operation of the pho-
tocells and their connection;
obstacle motor ;
Make sure there are no obstacles across the path of the gate and that
it slides smoothly;
Faulty encoder or disconnected from M1
Check wiring, check encoder by TEST-ENCODER (optional);
Reached maximum number of failed automatic closing attempts
Obstacle detected (only with dip 11 ON);
led off;
(red)
20