Install Door Handle And Seals - Kohler K-702010 Guia De Instalacion

Strike Jamb
Seal
Interior
Handle
Screw
Bushing
Threshold
8. Install the Door Handle and the Seals
Install the Door Handle
- Press the glass bushings into the handle holes in the operating panel.
- Identify the interior handle - the handle with holes going all the way through. Insert two flathead screws through
this handle and through the holes in the operating glass panel. Slide the bushings onto the screws.
- Align the exterior handle holes with the screws. Tighten the screws from the inside until snug using the 5/64"
hex wrench provided.
NOTE: Do not overtighten. Overtightening can cause damage.
Install the Strike Jamb and the Threshold Seals
- Insert the strike jamb seal into strike jamb channel. Trim the excess seal from the top.
- Remove the masking tape from the threshold.
- Starting at the strike jamb side, install the threshold seal into the groove on the threshold. The seal runs from the
end to the front of the hinge. Notch the foam portion around the strike jamb. Trim the excess seal at hinge.
CAUTION: Risk of product damage. Do not install the threshold seal under the hinge or the door will not
operate properly.
E
1011451-2-
Strike Jamb
Install the strike jamb seal,
and trim the excess
Exterior Handle
Threshold
Seal
Notch the foam portion of the
seal around the strike jamb
Install the threshold seal
10
Trim the excess threshold
seal at hinge
Kohler Co.