Install The Bottom Side Lite Bracket - Kohler K-702010 Guia De Instalacion

Note: If the 7" (17.8cm) side lite bracket is
used, use the 11" (27.9cm) threshold filler. If
the 13" (33cm) side lite bracket is used, use
the 17" (43.2cm) threshold filler.
Apply silicone sealant to
channel located under bracket
Channel
Channel towards
outside (dry side)
of shower

2. Install the Bottom Side Lite Bracket

- Insert the appropriate threshold filler into the side lite bracket in the groove located on top of the threshold. If the
7" (17.8cm) side lite bracket is used, use the 11" (27.9cm) threshold filler. If the 13" (33cm) side lite bracket is used,
use the 17" (43.2cm) threshold filler. Position the filler against wall on same side that the side lite panel will be
installed.
- Identify the bottom side lite bracket. When placed in the correct position on the threshold, the bracket weep slots
will be towards the inside (wet side) of the shower, and the channel will be towards the outside (dry side) of the
shower (weep slots and channel will be on opposite edges for the top side lite bracket).
- Place the side lite bracket on the threshold, flush against the wall and flush against the threshold filler.
NOTE: Be careful not to drill through the receptor ledge.
- Mark the hole location through the bracket hole and remove the bracket. Using the supplied 7/64" drill bit, drill a
hole through threshold at the location marked and clean out the filings.
- Apply silicone sealant to the channel on the bottom of the bracket and place on the threshold at its previous
location. Secure the bracket to the threshold using #6 20 x 3/8" screw.
E
1011451-2-
Threshold Filler
Threshold
Weep Slot
Weep slots towards inside
(wet side) of shower
4
#6-20 x 3/8" Screw
Bottom Side
Lite Bracket
Bracket Hole
Weep
Slot
Inside of Shower
Kohler Co.