Maxon 297077-01 Instrucciones página 3

LIFT CORPORATION Sht. 3 of 10 DSG#
3. Align hole in decal (Kit item) as
shown in FIG. 3-1 with the 10 mm
hole for mounting the switch. Attach
decal to panel as shown in FIG. 3-1.
NOTE: Switch cable (Kit item) must be cut
to length at the switch connection
depending on pump box location.
4. In the vehicle cab, crimp ring terminals (10-
12 AWG, Kit items) to the black wire and
white wire on the cab switch cable (Kit item)
(FIG. 3-2). Then, attach the black wire and
white wire to the terminals on the in-cab
switch (FIG. 3-2).
5. To attach the switch to vehicle cab, turn
the knob and hex nut counter-clockwise
to remove from switch (FIG. 3-3). Insert
switch bushing through 10 mm hole in
panel. Turn pal nut to adjust the distance
the bushing protrudes from panel. Re-
install hex nut to attach switch to panel.
Then, reinstall knob.
© MAXON Lift Corp. 2020
M-16-02
Rev. A Date: 08/03/20
10 MM HOLE
FOR SWITCH
ATTACHING SWITCH DECAL
FIG. 3-1
BLACK WIRE
10-12 AWG
RING TERMINALS
(2 PLACES)
CRIMPING IN-CAB SWITCH
WIRING TO TERMINALS
FIG. 3-2
DECAL
HEX NUT
KNOB
PAL NUT
ATTACHING SWITCH TO PANEL
FIG. 3-3
WHITE WIRE
BUSHING