Trace Measurement Of Prolite-50 - Promax PROLITE-50 Serie Manual De Instrucciones

USER'S MANUAL. PROLITE-50
The batteries are being recharged.
The batteries are fully recharged.
When the instrument is powered by inside rechargeable batteries, power volume
of batteries is shown on the LCD:
No power;
Low power;
Half power;
More than half power;
Full power.

5.2 Trace Measurement of PROLITE-50

One complete trace can be obtained for each measurement. Also, PROLITE-50
can load a saved trace.
NOTE: Before each measurement, if the operator is not familiar with the cautions,
please do follow instructions in this mnanual for personal safety.
Make sure that the optical fiber or cable is not in use and there is no laser
beam in the fiber before testing via PROLITE-50. Otherwise, it may result in
imprecise test trave, even permanent damage for the PROLITE-50.
In order to take a measurement correctly, we recommended to you observe the
following steps:
- Previously to clean connectors and joints
- Connexion of the optical fibre to measure
- Configuration of parameters
- Beginning of the measurement (Auto / Manual)
- Analysis of the result trace
01-2006 Page 23