Publicidad
K
234W
—
x 2
235W
x 3
4. Attach the Vertical Divider (A) to the Bottom Shelf (B) with Black Screws (K) (three in 235W and
two in 234W) through the predrilled holes in the Bottom Shelf and into the pilot holes in the bottom
edge of the Vertical Divider. Make sure the Rafix Cams (I) face down on the Bottom Shelf and
the wood trim faces out on the Vertical Divider. Start each screw part way into the Vertical Divider
before tightening all the rest of the way.
FIG. 5A
5. Attach the Left Side Panel (C) to the Bottom Shelf (B) by sliding the Rafix Bolts (J) into the
Rafix Cams (I). Tighten the cams. Repeat and attach the Right Side Panel (D) to the Bottom
Shelf (B). See FIGURE 5A.
Slide the Top (E) into place over the Left/Right Side Panels and Vertical Divider. Tighten the
Rafix Cams (I). Attach the Base (F) in place and tighten the cams. See FIGURE 5B.
FIG. 4
Center screw not used
on 234W base.
FIG. 5B
234W/235W — Page 5
Publicidad
