Publicidad
M
x 24
FIG. 6A
EQUAL
GAPS
TOP
FIG. 6B
6. With the unit laying face down on a protective surface, measure from top left to bottom right
(
) and from bottom left to top right (
line (
) is longer, tap bottom of Left Side Panel (C) until measurements are equal. If
line (
) is longer, tap bottom of Right Side Panel (D).
Connect the two Backs (G) together using two Plastic Back Channels (L). See FIGURE 6B
& 6C. Make sure there is a gap between the two individual channels to accommodate the
Vertical Divider and an equal gap from each edge.
Attach the Backs (G) to the unit using Screws (M). Make sure the bottom edge of the back is
flush with the bottom edge of the bottom shelf and equal distance from the sides.
Page 6 — 234W/235
). Measurements should be equal. If the
FIG. 6C
Publicidad
