Using The Protective Case; Environmental Protection - Benning MM P3 Instrucciones De Servicio

Do not unscrew any screws from the printed circuit of the

BENNING MM P3!
- Remove the discharged batteries from the battery compartment.
- Insert the new batteries into the battery compartment observing correct polarity,
(positive pole must point upwards).
- Put the bottom part of the housing back onto the upper part until it locks into place
and then tighten the screws.
See figure 9:
Make your contribution for environmental protection! Do not dis-
pose of discharged batteries via the household waste. Instead, re-

turn them to a collecting point for discharged batteries or special
waste. Please look for information in your community's facilities.
9.4 Calibration
To maintain accuracy of the measuring results, the device must be recalibrated in
regular intervals by our factory service. We recommend recalibrating the device once
a year. For this purpose, send the device to the following address:
Benning Elektrotechnik & Elektronik GmbH & Co. KG
Service Center
Robert-Bosch-Str. 20
D - 46397 Bocholt

10. Using the protective case

The safety measuring lines can be stored by winding them up and by fastening them
inside the protective case by means of the Velcro fastener.
See figure 10:

11. Environmental protection

At the end of product life, dispose of the unserviceable device via appropriate
collecting facilities provided in your community.
12/ 2007
Battery replacement
Using the protective case
BENNING MM P3

29