RIDGID R4030 Manual Del Operador página 15

ASSEMBLY
INSTALLING THE WATER PUMP
See Figures 13 - 14.
The pump recirculates water from the tray to the cutting
wheel.
 The pump is equipped with suction feet to secure in place.
Press down firmly on the pump to attach the feet to the
bottom of the water tray.
 Place the water pump's electrical cord under the frame rails
and over the left side of the frame as shown in figure 14.
 Push the end of the 90° fitting into the hole on top of the
water pump.
 Connect the clear hose to the barbed end of the 90°
fitting.
 Position the pump as shown in Figure 13, with the hose
end of the fitting facing the rear of the tray.
 Push back the rubber boot on the electrical cord and
plug the pump into the receptacle. Pull boot over cord
connections to help keep water off the plug.
CLEAR
HOSE
WATER
PUMP
RUBBER
BOOT
FILLING/CHANGING THE WATER RESERVOIR
See Figures 15 - 16.
 Fill the water reservoir with clean tap water to the fill line.
Do not fill past the Max Fill line on the tray.
To change reservoir water:
 Unplug the saw.
 Remove the drain plug and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
 Rinse the machine thoroughly.
 Discard the waste water in accordance with local
regulations.
 Replace the drain plug and refill tray with clean water.
FILL LINE
90°
FITTING
Fig. 13
DRAIN
PLUG
Fig. 14
15 — English
WATER
RESERVOIR
Fig. 15
Fig. 16