Changing The Position Of The Control Panel - Grundfos TPE 1000 Serie Instrucciones De Instalación Y Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

14. Changing the position of the control panel

It is possible to turn the control panel 180 °. Follow the
instructions below.
1. Loosen the four screws (T25) holding the terminal box cover.
Fig. 44 Loosening the screws
2. Remove the terminal box cover.
Fig. 45 Removing the terminal box cover
3. Press and hold in the two locking tabs (pos. A) while gently
lifting the plastic cover (pos. B).
Fig. 46 Lifting the plastic cover
4. Turn the plastic cover 180 °.
Note
Note
Do not twist the cable more than 90 °.
Fig. 47 Turning the plastic cover
5. Re-position the plastic cover correctly on the four rubber pins
(pos. C). Make sure that the locking tabs (pos. A) are placed
correctly.
Fig. 48 Re-positioning the plastic cover
6. Fit the terminal box cover, and make sure that it is also turned
180 ° so that the buttons on the control panel are aligned with
the buttons on the plastic cover.
Tighten the four screws (T25) with 3.7 lb-ft (5 Nm).
Fig. 49 Fitting the terminal box cover
29

Publicidad

Tabla de contenido
loading

Tabla de contenido